Filters

Electrostatic precipitator e-MOCarz was design for residential
buildings. Compact size and exceptionally low pressure drop
makes it suitable for residential heat recovery systems, with
little impact on system performance. The filtration efficiency
of ePM1 and ePM2.5 particles, the main component of
smog, is as high as 95%.
Polluted air initially passes through a steel mesh pre-filter
(which retains larger fractions), then is positively ionized in
an electric field due to the “crown discharge” effect. In the
last stage, the previously charged particles, are pulled by
electrostatic force toward horizontally mounted aluminium
plates (electrodes) and build up on their surface.
Electrostatic filters (precipitators) have low power consumption
(only few Watts), long service life and most of all there’s no
need to exchanged dirty (clogged) filters. It is enough to
clean in with water and detergent once or twice a year. There
is a led status indicator on the casing.

Available accessories:
e-MOCarz-W - renewable electrostatic filter, included in the set
e-MOCarz-ION - Ionizing module, additionally sterilizing and revitalizing air
e-MOCarz-CA - Activated carbon module, additional filtration of odors
e-MOCarz-... - round connector Ø160, Ø200, Ø250)

Duct mounted filters are designed for filtering air flowing through circular, spiral ducts. The duct filter box is provided with a class EU4 filter element
secured with a galvanized steel wire mesh on both sides. The casing of filter box is made of a round, galvanized sheet duct piece
with spigots fitted with seals for airtight connection.

How to replace a filter element?

Duct mounted filter boxes are equipped with a toggle clamp that allows easy replacement
of the filter element. Filter replacements for UFI filter box are available - UFI-W. The UFI duct filters are designed for installation
between the two sections of spiral duct in the standard diameter range (100-400 mm).

UFI-W is a class EU4 filter element designed for filtering air
flowing through round ducts. It is protected with a 1 mm
wire mesh of galvanized steel on both sides. The mesh size
is 1x1 mm on one side and 10x10 mm on the other.

The filter element casing is a 20 mm tall round duct piece.
The UFI-W filter elements are replaceable components of UFI duct filters.

The FSBQ-I filter elements are designed for use in the FSBQL
duct filters. The design of this filter element is very simple: the
filter element mat is sewn over a steel wire frame. The FSBQ-I
filter elements are available in filtration classes EU3 and EU5.

The filter elements can be fabricated on request with an
activated carbon mat rated at EU4.
All filter elements are wrapped in protective plastic film which
must be removed before installation.

The FSCQ cartridge filters are designed for filtering air flowing
through square ducts. The casing of each FSCQ cartridge filter
is the square duct in which it is installed. The cartridge filter
is inserted into the square duct from above, and then locked
and sealed in place with clasps.

This design of the FSCQ cartridge filter allows easy replacement
of the filter element. The filter element is made of a pleated filter
element mat protected by a galvanized steel wire mesh. The
FSCQ cartridge filters can be provided with class EU3/G3, EU4/G4,
EU5/G5, and EU6/G6 filter elements. Optional filter elements
include versions for separation of grease fumes and oil mist
vapour. The cartridge filters are available in aluminium,
galvanized steel or stainless steel for long service life and
regenerability.