We are extending the FlatAIR range of parallel-flow heat rocovery unit with further capacities in order to adapt even better to project requirements.
The smallest unit with a capacity of 80 m3/h and further units to choose from: 100, 120, 125, 150, 200, 225 and 250 m3/h.
The paraller-flow design of the heat rocovery unit means a specific arrangement of duct connections in which the air inlet and outlet are located on one axis. This arrangement of ductwork allows the unit to be connected more quickly and intuitively and facilitates installation in narrow spaces.
These and other products for ventilation and heat recovery can be found in the PRODUCTS section
Complete selection of components
Based on the set parameters, AlnorSELECT will match air handling units, ducts, manifolds and boxes
Increased conversion efficiency
Each change of settings results in an instantaneous recalculation of the selection result
Faster selection through templates
Manual setting of criteria or loading of pre-sets available
Intelligent plausibility check
The programme optimises the selections and relieves the user of time-consuming tasks
Autodetection of errors and friendly prompting system
Any inconsistencies in the entered parameters are detected and correction suggestions are immediately displayed
Automatic dispatch of the selection report
The selection result can be saved as a PDF file or sent immediately to an ALNOR consultant for verification
These and other products for ventilation and heat recovery can be found in the PRODUCTS section
These and other products for ventilation and heat recovery can be found in the PRODUCTS section